Using XF86_W32 on a board with an ICS5341 GENDAC

Information for W32 and ET6000 Chipset Users : Using XF86_W32 on a board with an ICS5341 GENDAC
Previous: Information for W32 Chipset Users
Next: Using XF86_W32 on a board with an STG1703 GENDAC

2. Using XF86_W32 on a board with an ICS5341 GENDAC

Even though the GENDAC provides a set of standard clocks that can be found with the normal clock probing procedure, it is mandatory to put a


ClockChip  "ics5341"

line into the Device Section to be able to use the programmable clocks that the ICS5341 can produce. You can also add a


Ramdac     "ics5341"

line, but the RAMDAC should be auto-probed correctly. Even though the server currently accepts any dot clock up to 135MHz with the ICS5341 GENDAC, most boards show a small band of clock values in the area between 86MHz and about 100MHz that don't work. This are usually is just a few MHz wide, higher clocks as well as lower clocks work just fine. I'm working on it. (DHH)